As far as the only problem I found was with the Charging, however, using another charger solved that problem too. Right now there is nothing that I have seen in it, that would change my mind to revert back to the Mahdi ROM. In this article, we will show you How to Install XenonHD Android 5.0.2 Lollipop on Nexus 4. If you are interested in Other ROMs, you can Visit our Custom ROMs section or you can install this ROM on your Nexus 4 by following our tutorial below. This is not an official release from Google but a Custom ROM. Installation procedure uses the Fastboot commands to install this custom ROM. Your device must be rooted. Let’s go through the ROM features and early preparations and then flash this ROM.
÷Early Preparations:
•This is only for Nexus 4!
•Battery should be charged at least over 60%
•Unlock Bootloader Of Your Device.
•Flash a Custom Recovery and Root Your device
•Backup SMS Messages
•Backup Call Logs
•Backup Contacts
•Backup Media – Copy your files manually to your PC or Laptop.
Titanium Backup – If already rooted, use Titanium Backup to backup all of your apps, system data and other important content.
•Backup Nandroid - If CWM or TWRP installed previously, otherwise skip this step and perform this at the end of flashing.
*Disclaimer:
We provide various Firmware Updates and Rooting process along with Custom ROM,Modes,file are all belong to their owners/developers. The autor of this site or the developers are not responsible, if you damage or brick your device.Do it on your own risk and follow the instruction properly.
÷How to Install XenonHD ROM:
1- Download XenonHD Custom ROM & Gapps on your PC.
2-Connect your device with PC.
3-Copy and Paste the Above zip files to the root of your sdcard.
4-Open Recovery mode. How?
Connect your device with PC
Open Command Prompt in Fastboot folder. (ADB and Fastboot Tools Installer)
5-Now Type: adb reboot bootloader
Choose Recovery from Bootloader
6-Back-up your ROM using the Recovery.
7-To Perform a Back-up, Navigate to Back-up and Restore on Next screen, Choose Back-up again.
8-Go back to Main Screen after the Back-up is complete.
9-Then Navigate to ‘advance’ and choose ‘Dalvik Wipe Cache’, so you won’t get in any bootloop.
10-Navigate to ‘Install zip from sd card’ another windows will open in front of you.
11-Finally Select “Wipe Data/Factory Reset”
12-Select ‘choose zip from sd card’ from the Options.
13-Select the update-XenonHD-01-04-15-signed-mako.zip.zip file and confirm the installation on next screen.
14-Go Back and Flash Gapps.zip
Once the Installation is Over, Select +++++Go Back+++++
15-Select Reboot Now to Reboot the System.
The First boot might take up-to 5 minutes, so please be patient.
Best regards..