1. This is only for Galaxy Note 2 N7100!
This custom ROM is only for the device mentioned above. Make sure that your model number matches the one listed above. To do so, go to Settings > About Device on your device and see your model number. Flashing this ROM on any other device will result in bricking it so make sure that you meet this requirement first of all.
2. Battery should be charged at least over 60%
Make sure that your battery is charged enough to complete the flashing process. In case your battery is low and your device goes dead during the flashing process, you may end up soft bricking your device as it won’t complete the flashing process.
3. A Custom Recovery and Rooted device required.
4. Backup everything!
Just to be on the safe side, you may consider backing up each and everything from your Android device. This is highly recommended so that in case anything goes wrong, you still have the access to all of your data and you can restore it immediately. You may backup everything as listed below.
Backup SMS Messages
Backup Call Logs
Backup Media – Copy your files manually to your PC or Laptop.
Titanium Backup – If already rooted, use Titanium Backup to backup all of your apps, system data and other important content.
Backup Nandroid - If CWM or TWRP installed previously, otherwise skip this step and perform this at the end of flashing.
We provide various Firmware Updates and Rooting process along with Custom ROM,Modes,file are all belong to their owners/developers. The autor of this site or the developers are not responsible, if you damage or brick your device.Do it on your own risk and follow the instruction properly.
1- Download CM12 Lollipop 5.0
2- Download Lollipop 5.0 Gapps
3- Connect your device with PC.
4- Copy and Paste the Above zip files to the root of your sdcard.
5-Disconnect the cable.
Turn Off your Device
6- Open Recovery mode. How? Press and hold the Volume Up + Home + Power buttons until you see some text on screen.
CWM/PhilZ Touch Recovery Users.
7- Back-up your ROM using the Recovery.
To Perform a Back-up, Navigate to Back-up and Restore on Next screen, Choose Back-up again.
8- Go back to Main Screen after the Back-up is complete.
9- Then Navigate to ‘advance’ and choose ‘Wipe Dalvik Cache’, so you won’t get in any bootloop.
10- Finally Select Wipe Data/Factory Reset
Navigate to ‘Install zip from sd card’ another windows will open in front of you.
11- Select ‘choose zip from sd card’ from the Options.
12- Select the CM 12.zip file and confirm the installation on next screen.
13-Go Back and Flash the Gapps.zip
Once the Installation is Over, Select +++++Go Back+++++
14- Select Reboot Now to Reboot the System.
÷ Solve Signature Verification Error:
•Navigate to install zip from Sdcard
•Navigate to Toggle Signature Verification and Press Power Button and See if it is disabled or not. Disable it and then Install the Zip without any Error.
First Boot might take up-to 5-minutes, so let your device rest for 5-minutes as you do something else.
PLZ Use The Comment Section And Don’t Forget To Share This post With Your Friends & your Social World
Best regards …©